sbs waterproofing membrane manufacturers take you to understand what problems are in construction

As a waterproofing membrane, sbs waterproofing membrane plays an important role in the construction process, and the waterproofness of this product is better than other waterproofing materials, but there may be some problems during construction , the following sbs waterproofing membrane manufacturers to share with you what are the common problems!

The common problems of sbs waterproofing membrane overlap mainly include the following two points:
1. The overlapping parts of the waterproof membrane are not dense, and the overlapping width is not enough.
2. The surface of the coil is wrinkled or warped.
As for why these problems occur, it is actually very simple, mainly related to the methods and methods in the construction process.
The sbs waterproofing membrane manufacturer tells you that if the lap joint is not tight, it may be that the construction personnel did not evenly level it when laying it, and the width is insufficient, so the reserved width for the lap joint is not enough.
The curling edge of the coil may be caused by not strictly following the construction process during construction, and the lap joints are not firmly attached, which leads to the subsequent curling and bonding problems. This situation will cause the waterproofing of the sbs waterproofing membrane to be affected to a certain extent. Therefore, in order to prevent this from happening, care must be taken during the construction process.
The above content is mainly to introduce to you the problems related to the construction of sbs waterproofing membrane, I hope you can read it carefully.